Samson A6 User Manual

• 

 Lower your mixer’s master outputs to all the way off. 

  

• 

 Connect the mixer’s Left Control Room output to the left-side Resolv A Series LINE INPUT and the 

mixer’s Right Control Room output to the right-side Resolv A Series LINE INPUT.  

• 

Set the Resolv A Series input Volume control to the 2 o’clock position. 

•  

 Run an audio signal (like some music from a CD) through your mixer and raise the Control Room level 

to a comfortable listening level.

Note: Before plugging in and turning on, remember the “last on, first off” rule of power amplifiers (and pow-

ered monitors). When powering up your system, be sure that all the wires are connected, turn your mixer 

and any other outboard gear on, and then last turn your Resolv A Series on.  When powering down, turn your 

Resolv A Series off first and then your mixer and outboard gear. 

The Resolv A Series connections can be made via one of the three rear panel Audio Inputs.  You can use RCA 

inputs for unbalanced -10dBV level signals, or either the 1/4-inch or XLR inputs for balanced, +4dBu level sig-

nals.  Follow the simple steps and diagram below  for a quick connection using a standard recording console’s 

control room outputs.

8