Thermador PCS484WK User Manual
SAFETY
ELECTRICAL REQUIREMENTS AND GROUNDING INSTRUCTIONS
CAUTION - ALL MODELS
In Case of an Electrical Failure
If for any reason a gas control knob is turned ON and there is no electric power to operate the
electronic igniters on the cooktop burners, turn OFF the gas control knob and wait 5
minutes for the gas to dissipate before lighting the cooktop burner manually.
electronic igniters on the cooktop burners, turn OFF the gas control knob and wait 5
minutes for the gas to dissipate before lighting the cooktop burner manually.
To light the cooktop burners manually, carefully hold a lighted match to the burner ports and
turn the gas control knob to HI. During a power failure, you can manually light the standard
cooktop burners only, but each must be lit with a match.
turn the gas control knob to HI. During a power failure, you can manually light the standard
cooktop burners only, but each must be lit with a match.
DO NOT attempt to light the two left burners manually. These burners are equipped
with the ExtraLow® feature and cannot be lit manually.
with the ExtraLow® feature and cannot be lit manually.
See Pages 11 and 29 for additional information on manually lighting the burners.
SECTION ONE: GENERAL SAFETY INSTRUCTIONS
PLEASE READ CAREFULLY
All Cooktop models and the Wok require an elec-
trical circuit rated at 120 volts, 60 Hz., 15 Amps.
trical circuit rated at 120 volts, 60 Hz., 15 Amps.
For personal safety, this appliance must be
connected to a properly grounded and
polarized electrical power supply.
connected to a properly grounded and
polarized electrical power supply.
Always disconnect the electrical plug from the wall
receptacle before servicing this unit.
receptacle before servicing this unit.
See Installation Instructions for electrical
requirements and grounding instructions.
requirements and grounding instructions.
DO NOT UNDER ANY
CIRCUMSTANCES CUT OR REMOVE
THE SEPARATE GROUND WIRE OR
THE THIRD (GROUND) PRONG
FROM THE POWER CORD PLUG.
CIRCUMSTANCES CUT OR REMOVE
THE SEPARATE GROUND WIRE OR
THE THIRD (GROUND) PRONG
FROM THE POWER CORD PLUG.
It is the personal responsibility and obligation of
you, the user, to have this appliance connected to
the electrical power supply in accordance with the
National Electrical Code and/or applicable local
codes and ordinances by a qualified electrician.
you, the user, to have this appliance connected to
the electrical power supply in accordance with the
National Electrical Code and/or applicable local
codes and ordinances by a qualified electrician.
It is recommended that a dedicated circuit servic-
ing this appliance be provided.
ing this appliance be provided.
!
Page 2