Edelbrock 5274 User Manual

Page

1 of 2

Catalog #5274

Rev. 5/06 - DA/mc

EDELBROCK LOWER TRAILING ARMS

for 1982-2002 Camaro / Firebird

Catalog #5274

INSTALLATION INSTRUCTIONS

Please study these instructions carefully before installing your new Trailing Arms. If you have any questions, please
contact our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday through Friday, Pacific Standard Time
or e-mail us at Edelbrock@Edelbrock.com. Please fill out and mail your warranty card.

Application: Designed for 1982-2002 Camaro/Firebird vehicles. These trailing arms are designed to stabilize the rear
suspension, while improving suspension articulation.

Suggested Tools for Installation:

❑ Jack and proper load rated jackstands

❑ Blue Locktite

❑ Tire chocks

❑ Torque wrench

❑ Lug wrench

❑ Grease gun

❑ 18mm socket and combination wrench

Place vehicle on level surface and place tire

chocks in front of and behind front tires.

Support rear of the vehicle on the jackstands

and remove the rear wheels

(See Figure. 1).

Place a floorjack under the differential and lift up

slightly to remove tension from the trailing arm

bolts. Make sure not to lift the vehicle off the

jackstands

(See Figure 1).

NOTE: Keep floorjack under vehicle during

the complete removal and installation

procedure.

CAUTION: Do not remove both trailing arms

at the same time or the axle will rotate and

the trailing arm installation will be much

more difficult.

Remove trailing arm bolts and trailing arms

(See Figure 2).

REMOVAL OF STOCK TRAILING ARMS

Fig. 1

IMPORTANT NOTE:

Proper installation is the responsibility of the installer. Improper installation will void warranty and may

result in poor performance and engine or vehicle damage.

Fig. 2