Alliance Laundry Systems 504523R3 User Manual
8
504523
Meter Case . . .
(Metered Models)
The factory mounted coin meter case does not include the
service door lock, coin drawer, coin drawer lock and
keys. These parts must be ordered (at extra cost)
according to the purchaser’s requirements direct from the
manufacturer of your choice.
service door lock, coin drawer, coin drawer lock and
keys. These parts must be ordered (at extra cost)
according to the purchaser’s requirements direct from the
manufacturer of your choice.
NOTE: You have the option of using a screw type lock
or a 1/4 turn lock on the meter case service door. If
you choose to use a screw lock, then the special
bracket (located inside the meter case) must be used.
DO NOT use the special bracket if a 1/4 turn lock is
used.
or a 1/4 turn lock on the meter case service door. If
you choose to use a screw lock, then the special
bracket (located inside the meter case) must be used.
DO NOT use the special bracket if a 1/4 turn lock is
used.
Coin Drawer Security — for additional security, drill
out the two pilot holes on each front side of the meter case
to 1/4 or 5/16 inch (6.4 or 8.0 mm) holes and install a
bicycle lock through these holes.
out the two pilot holes on each front side of the meter case
to 1/4 or 5/16 inch (6.4 or 8.0 mm) holes and install a
bicycle lock through these holes.
Timer Cams . . .
(Metered Models)
The dryer timer is factory equipped with a 45 minute
timing cam. If this drying time is not suitable to your
timing cam. If this drying time is not suitable to your
installation, the following cams can be found in the
envelope located in the cylinder:
envelope located in the cylinder:
Electric Dryers
Gas Dryers
1-53242 Cams (30 Minutes)
1-53242 Cams (30 Minutes)
1-53240 Cams (60 Minutes)
A 60 minute timing cam, Part No. 53240, is available for gas
dryers as optional equipment at extra cost.
dryers as optional equipment at extra cost.