Alliance Laundry Systems 504523R3 User Manual
504523
11
Installing the Dryer . . .
STEP 1:
Position and Level
the Dryer
the Dryer
For further assistance refer to Section on Location
Requirements.
Requirements.
Install dryer before washer. This allows room for
attaching exhaust duct.
attaching exhaust duct.
Install the four rubber cups found in the accessory bag.
Place the dryer in position, and adjust the legs until the
dryer is level.
dryer is level.
STEP 2:
Connect Dryer Exhaust System
For further assistance refer to Sections on Location
Requirements and Dryer Exhaust Requirements.
Requirements and Dryer Exhaust Requirements.
• DO NOT use plastic or thin foil flexible ducting.
• Locate dryer so exhaust duct is as short as possible.
• Be certain old ducts are cleaned before installing your
new dryer.
• Use 10.2 cm (4") diameter rigid or flexible metal duct.
• Use as few elbows as possible.
• Use duct tape on all joints.
• Failure to exhaust dryer properly will void
warranty.
NOTE: Venting materials are not supplied with the
dryer (obtain locally).
dryer (obtain locally).
IMPORTANT: DO NOT block the airflow at the
bottom of the dryer’s front panel with laundry, rugs,
etc. Blockage will decrease airflow through the dryer,
thus reducing the efficiency of the dryer.
bottom of the dryer’s front panel with laundry, rugs,
etc. Blockage will decrease airflow through the dryer,
thus reducing the efficiency of the dryer.
D334IE1A
LEVEL
DRYER
BASE
LEVELING
LEG
RUBBER
CUP
A clothes dryer produces combustible lint. To
reduce the risk of fire and combustion gas
accumulation the dryer MUST be exhausted to
the outdoors.
reduce the risk of fire and combustion gas
accumulation the dryer MUST be exhausted to
the outdoors.
W116
WARNING
DO
D333IE1A
DON’T
D335IE1A