Alliance Laundry Systems h236i User Manual
8
685945
Step 2:
Connect Water Inlet Hoses
NOTE: Refer to section on Water Supply
Requirements before connecting water inlet hoses.
Requirements before connecting water inlet hoses.
Remove the four plain rubber washers from accessories
bag, and install them according to the illustration.
bag, and install them according to the illustration.
Turn on the water supply faucets and flush the lines for
approximately two minutes to remove any foreign
materials that could clog the screens in the water mixing
valve.
approximately two minutes to remove any foreign
materials that could clog the screens in the water mixing
valve.
NOTE: When installing in newly constructed or
renovated building, it is very important to flush the
lines since build-up may have occurred during
construction.
renovated building, it is very important to flush the
lines since build-up may have occurred during
construction.
IMPORTANT: Thread hose couplings onto valve
connections finger-tight, then approximately 1/4 turn
with pliers. DO NOT cross thread or overtighten
couplings.
connections finger-tight, then approximately 1/4 turn
with pliers. DO NOT cross thread or overtighten
couplings.
Turn water on and check for leaks. If leaks are found,
retighten the hose couplings. Continue tightening and
rechecking until no leaks are found.
retighten the hose couplings. Continue tightening and
rechecking until no leaks are found.
RUBBER WASHER
(Plain)
H091IE1A
INSTALL THIS
END OF HOSE
TO WATER
SUPPLY FAUCET
INSTALL THIS END OF HOSE
TO VALVE CONNECTIONS
AT REAR OF WASHER
INLET
HOSE
HOSE
RUBBER WASHER
(Plain)
H100IE1A
COLD WATER
CONNECTION
CONNECTION
HOT WATER
CONNECTION
WATER SUPPLY
FAUCETS
WATER INLET
HOSES