American Power Conversion back ups bh500net User Manual
INSTALLATION
w
w
w.apc.com
®
Back-UPS HS 500
User’s Manual
990-9234 2/04
3
Remove Battery
(if wall-mounting - if not proceed at Step 5)
32 - 104
o
F (0 - 40
o
C)
1
Placement
2
Remove Connector Cover
Disconnect battery
wires from battery.
Caution: To prevent damage to the ribbon cable (not shown)
that connects the cover to the UPS, replace the cover after
removing the battery. Do not disconnect the ribbon cable
from the cover or the UPS.
Remove battery.
Press cover release
tab (one each side)
and remove cover.
Press the outlet cover release
tab (one each side); and pivot
cover off the unit.
Phone Line Out
w w w.apc.com
®
4
Mount Back-UPS (optional)
Wall Anchor
Mounting
Hole
Wall
5
Connect and Install Battery, Install Battery Cover
Install battery cover.
Press the outlet cover
release tab (one each
side); and pivot cover
off the unit.
Connect and install
the battery..
6
Connect Cable Modem,
Circuit Breaker
Push to Reset
Cable Out
Input:
120V~, 10A, 50-60Hz
Cable In
From Cable Provider
(Phone, Internet,
and/or CATV; or
DSS)
To Cable Modem,
VCR, DSS or TV
Cable Box
7
Connect Phone Line
LAN
Network
Modem/Phone/Fax
RJ-45
Connectors
(will accept RJ-11)
RJ-45
Connectors
Phone Line In
(Standard or
DSL)
From Network Device
(or Computer Using a
Crossover Cable)
From Modem
DSS or CATV Receiver
8
10
Install Connector Cover
Align the holes in the
cover with the connector
cover release tabs (one
each side) and lower
connector cover.
(optional)
or DSL to Surge
Connect Network
Equipment
To Hub or
Router
11
Connect to Power Source
and Switch on UPS Power
Connect Equipment
Hub
or Router
Modem
Network Device
Network Device
Output 1
Output 2
Output 3
Output 3
9
Power Cords
Check the Building Wiring Fault indicator. If this
light emitting diode (LED) is illuminated, it is an
indication that a potential shock hazard exists. Have
the building wiring inspected and repaired by a
qualified electrician.
Building Wiring
Fault Indicator
12
Check the Building
Wiring Fault Indicator
to Surge Protection
Protection (optional)
NOTE: APC recommends your network equipment
(computer, modem, router, hub, or other networked
devices) be completely installed, configured, and
tested prior to adding this UPS to the network.