Silex Technology SX-200 User Manual
User’s Guide
Document #40182-420 Rev. A
80
Enable or disable WPA/WPA2 group key mode. If enabled, this allows group keys to be used for data link
encryption.
SET NW WPAGROUP [ENABLE | DISABLE]
(default = disabled)
encryption.
SET NW WPAGROUP [ENABLE | DISABLE]
(default = disabled)
SH NW WPAGROUP
Shows the state of the allow WPA/WPA2 group keys flag
sample output:
WPA-GROUP Disabled
WPA-GROUP Disabled
SET NW WPAPSK
Sets the WPA/WPA2 PSK pass phrase or hex key. This value is only used if the authentication mode is
WPA-PSK. The argument to this command is either a pass phrase of 8-63 characters, or exactly 64 hex
characters representing the 256 bit PSK value.
WPA-PSK. The argument to this command is either a pass phrase of 8-63 characters, or exactly 64 hex
characters representing the 256 bit PSK value.
SET NW WPAPSK <key>
(default = “silex”)
(default = “silex”)
SET NW WPATRACE
Sets the WPA trace level. note: this command is for diagnostic purposes only, and should not normally be
used as the trace can affect performance. A value of 0 disables the trace.
used as the trace can affect performance. A value of 0 disables the trace.
SET NW WPATRACE nn
(default = 0)
(default = 0)