Thermador gas star sgs365 User Manual

English 6

To operate: Select the appropriate control knob, push down and turn counter-
clockwise to the desired flame size. Turn OFF by turning the control knob clock-
wise to the •, indicating OFF.

The bezels for standard burner controls feature one unnotched area on the under-
side. This single area snaps into the straight area in the cooktop so that OFF is at 
the 12 o’clock position.

To remove knob and bezel: With burner in the OFF position, gently lift knob up 
and off. Gently lift the bezel from the sides and pull up.

 To avoid possible electric shock, do not reach through 

bezel opening into rough-in box.

To replace bezel and knob: With the • on the bezel in the 12 o’clock position, 
press to snap in place. Replace control knob by placing indicator line at the 12 
o’clock position; press down firmly. For models SGSX only, be sure to replace 
ExtraLow® bezels in the 2 left burner positions.

Two burners are enhanced with the ExtraLow (XLO®) feature. When the control 
knob is set within the XLO® zone, the flame cycles OFF and ON automatically for 
varying seconds every minute. This cycling is normal and allows you to simmer, 
poach, melt or hold cooked food without scorching or burning.

•

The burner flame will cycle ON and OFF each minute when the setting is at 
any position between LO (past detent) and XLO.

•

The length of time the flame is ON and OFF depends on the knob setting.

•

With a setting just below LO, the flame will be ON approximately 53 seconds 
and OFF 7 seconds of each minute.

•

With a setting at the XLO position, the flame is ON approximately 7 seconds 
and OFF 53 seconds of each minute.

•

The knob can be set to any position between LO and XLO.

 Do not clean or touch any of the burners when one or 

both XLO burners are in use. When the XLO burner automatically reig-
nites, the igniter at the burner will spark.

EXTRALOW BURNER CONTROL