Edelbrock victor 28095 User Manual

Catalog #29085, #28095
Rev. 1/08 - AJ/mc

Page 1 of 2

©2008 Edelbrock Corporation

Brochure #63-0341

PLEASE study these instructions carefully before installing your new Intake Manifold. If you have any questions or problems, do not
hesitate to contact our Technical Hotline at: 1-800-416-8628, from 7am-5pm PST, Mon-Fri, or via e-mail at:
Edelbrock@Edelbrock.com

CAUTION: Make sure the vehicle’s battery has been disconnected and that the vehicle is supported on a level surface to prevent any
possibility of the vehicle moving during the installation procedure.

MANIFOLD: The single plane Victor Jr. LS1 Intake Manifold is intended for racing and engine swap applications. A fuel rail kit
designed to work with this manifold may be purchased as part #3638.

EGR SYSTEM: This manifold has no provision for EGR (exhaust gas recirculation) equipment. EGR systems are used on most 1972
and later model vehicles, up to certain GVWs. Check local laws for requirements. This manifold is not considered to be a direct
replacement part.

ACCESSORIES & INSTALLATION ITEMS: Major recommendations are listed below. However, because this manifold system is
intended for engine swaps into a variety of vehicles, some customization may be required.

Throttle Body

Standard Square-Bore Style Base

P/N 3878 - With standard GM/Delphi IAC
P/N 38783 - With Mototron/Hitachi Linear Style IAC

Fuel Rail Kit

Stock Injector Angles

P/N 3638 - Includes Hold Down Brackets

Headers

1-3/4” - 1-7/8” Step, Victor Series

Various. See Catalog For Details

Camshaft

Developed for Carbureted Applications

P/N 2215 - 220° Int./224° Exh. @ .050”, .510” Valve Lift
P/N 2216 - 230° Int./237° Exh. @ .050”, .540” Valve Lift

❑ 1

Intake Manifold

❑ 1

MAP Sensor Bracket (For LS1 Style Sensor)

❑ 1

1/8”NPT to ¼” Hose Fitting (For MAP)

❑ .75 ft

¼” I.D. Vacuum Hose (For MAP)

❑ 2

Cable Bracket (Large Opening)

❑ 2

Cable Bracket (Small Opening)

❑ 1

GEN III EFI Throttle Bracket Base

❑ 4

6mm x 1.0 x 12mm Serrated Flange Hex Bolt

❑ 4

6mm x 1.0 Serrated Flange Hex Nut

❑ 10

6mm x 50mm Hex Head Capscrew

❑ 10

¼” AN Washer

3/8” NPT

1/8” NPT