Philips 26hf5443 User Manual

The message “WRONG VERSION” is displayed on the screen.  
=> The program stored into the Wireless Smart-Loader has a software code incompatible with 

the actual  TV. Reprogram the Wireless Smart-Loader from a master TV whose software code 
is compatible with the actual TV. 

 
1. The message “I2C ERROR” is displayed on the screen. 

=> Bad connection of RJ11 wire or wrong data transmission occurred. Please check the RJ11 
connection and try again. 

 
2.  TV doesn’t respond to the Wireless Smart-Loader. 

=> check if the LED on the Wireless Smart-Loader is green when pressing any button and 
check if the batteries are in a good condition.  Replace batteries if necessary. 

=> try to bring the Wireless Smart-Loader more closer to the TV infra red receiver and try 
again. 

 
Tips: 

1.  Do not forget to write the software code and the type of relevant master TV on the sticker 
used on the back of the Wireless Smart-Loader. 

2.  In case of empty or no batteries available, it remains possible to install TVs using the “wired 
method” of the Wireless Smart-Loader.  

3.  The Wireless Smart-Loader can retain, without batteries, the stored information for ten years 
if required. 

 
NOTE: 

 

Before putting the Wireless Smart-Loader into store for a long time, make sure that the 

batteries are all taken out to prevent the batteries corroding the contacts. 

 

Wired Smart-Loading works with CRT TVs only. Wireless Smart-Loading works with both 

Flat TVs and CRT TVs.  

 
 

 

 

Press the 

 key for approximately 5 seconds. The following text then appears: 

 

 

 

If the word “LOW” appears instead of “OK”, the remote control batteries are low and must be replaced. 

 

                                               - 19 -