Philips az1119 User Manual

Whenever convenient, use the mains supply if you want to conserve 
battery life. Make sure you remove the mains plug from the set and
wall socket before inserting batteries.

Open the battery compartment and insert as shown six batteries, 
type R20, or D-cells.

Replace the compartment door, making sure the batteries are
firmly and correctly in place.

Remove the batteries if exhausted or if they will not be used
again for a long period.

– The incorrect use of batteries can cause electrolyte leakage and

will corrode the compartment or cause the batteries to burst.
Therefore:

– Do not mix battery types, e.g. alkaline with zinc carbonate.
– When inserting new batteries, replace all batteries at the same

time.

The battery supply is switched off when the set is connected
to the mains. 

Check if the mains voltage as shown on the type plate (on the
bottom of the set) corresponds to your local mains voltage. If it
does not, consult your dealer or service organisation.

If your set is equipped with a voltage selector, set it to the local
mains voltage.

Connect the mains lead to the MAINS socket and the wall
socket.
– The set is now ready to use.

To switch off the mains supply completely, pull the  mains plug
out of the wall socket.

– Disconnect the mains lead when you change over to battery

supply, or to protect the set during heavy thunderstorms. 

All redundant packaging material has been omitted. We have done our utmost to make the packaging 
easily separable into three mono materials: cardboard (box), expandable polystyrene (buffer) and
polyethylene (bags, protective foam sheet).
Your set consists of materials which can be recycled if dissassembled by a specialized
company. Please observe the local regulations regarding the disposal of packaging
materials, exhausted batteries and old equipment.

5

AZ 1110/14 page 5