Philips bclever sv1 User Manual
>
If a fault occurs, first check the points listed below before taking the projector for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service
organisation.
If you are unable to remedy a problem by following these hints, consult your dealer or service
organisation.
Under no circumstances should you try to repair the projector yourself as this could invalidate the
guarantee.
guarantee.
–
Possible cause
•
Solution
General
–
–
Mains lead is not correctly connected.
•
Correctly connect mains lead.
–
The filter holder is not installed correctly or is damaged.
•
Install the filter holder correctly (see ‘Cleaning the dust filter’ under ‘Maintenance’).
–
Lamp holder cover is not closed correctly or the lamp holder is damaged.
•
Close the cover correctly (see ‘Lamp replacement’ under ‘Maintenance’).
–
Signal cable not correctly connected.
•
Connect signal cable correctly.
–
The projector is in Off position.
•
Press
y
Standby to switch on the projector.
–
A/V Mute active.
•
Cancel A/V Mute.
–
Projector still uses settings of a previous detected source on the input.
•
Reset all projector settings in the ‘Set up’ menu (‘Factory settings’).
Please note that all other projector settings will be reset as well.
In Data mode
– Input resolution is too high (and keystoning is applied).
– Input resolution is too high (and keystoning is applied).
•
If you wish to keep the keystone correction, decrease the input resolution until the image is
correctly displayed. For this, refer to the User Guide or support information of the computer.
correctly displayed. For this, refer to the User Guide or support information of the computer.
•
If you wish to keep the input resolution as it is, decrease keystoning until the image is
correctly displayed. For this, use the
correctly displayed. For this, use the
Keystone
buttons on the remote control or the
‘Keystone’ option in the ‘Set up’ menu.
– Input resolution is too high (and no keystoning is applied).
•
Decrease the input resolution until the image is correctly displayed. For this, refer to the User
Guide or support information of the computer.
Guide or support information of the computer.
In Component Video mode
–
–
Keystoning is applied on a high resolution component signal.
•
Decrease keystoning until the image is correctly displayed. For this use the
Keystone
buttons on the remote control or the ‘Keystone’ option in the ‘Set up’ menu.
Warning
Read as follows
Problem
Image is not or incorrectly
displayed
Note
Philips Multimedia Projector
34
English User guide bClever SV1
7. Troubleshooting