Philips ct1218-fmus10p2 User Manual
3
Getting started
L
Read the safety instructions in the "Precautions" section before use.
Inserting the SIM card
Charging the battery
L
Your phone is powered by a rechargeable battery.
•
•
For a full recharging please allow the charger to be connected for about 10
to 14 hours (e.g., over night).
to 14 hours (e.g., over night).
•
To optimise battery capacity, allow it to fully discharge 3 times in a row.
Then, to maintain its optimal capacity, do not wait until the indicator
reaches low (i.e., when only 1 bar is displayed in the battery indicator).
Then, to maintain its optimal capacity, do not wait until the indicator
reaches low (i.e., when only 1 bar is displayed in the battery indicator).
•
Disconnect the battery if you do not use the phone for several days.
•
You can use the phone while it is on charge.
•
If the battery is completely flat, the battery icon will only reappear after 2
or 3 mn of recharging. Meanwhile, you cannot make a call.
or 3 mn of recharging. Meanwhile, you cannot make a call.
1
Once the battery and the battery cover are connected to the phone, plug
the connector into the right hand socket at the base of the phone.
the connector into the right hand socket at the base of the phone.
1
Remove the SIM card from its holder and insert in its slot,
under the metal clip holder, push until it stops. Be careful that
the clipped corner of the card is in the correct position as
shown opposite.
under the metal clip holder, push until it stops. Be careful that
the clipped corner of the card is in the correct position as
shown opposite.
2
Slide the battery pack into its slot until it stops (1) and push
the clip downwards (2).
the clip downwards (2).
3
Place the phone’s battery cover, by sliding it until the latch
catches.
catches.
4
Remove the protective film from the screen before using the
phone.
phone.
Fisio121_GB_4311 255 53212.book Page 3 Lundi, 27. mai 2002 3:08 15