Philips HTR5205 User Manual

21

Before you start...
Please make sure the FM and AM/MW 
antennas are connected.

A

 Press SOURCE repeatedly until ‘FM’ or 

‘AM/MW’ appears on the display panel. 

(or press RADIO on the remote control).

B

 Press W or X on the remote control to 

start tuning.

 

The display panel will show ‘SEARCH’  

change until a radio station with suffi cient 
signal strength is found.

C

  Repeat step 

B

 if necessary until you fi nd 

the desired radio station

D

  To fi ne-tune the reception of a weak      

station, press S or T briefl y and           
repeatedly until an optimal reception is 
found.

(only applicable for certain regions)
In some countries, the frequency step 
between adjacent channels in the 
(AM/MW)/ FM band is 9 kHz/ 50 kHz 
(10 kHz/100 kHz in some areas).

Note:
Changing the tuning grid erases all 
previously stored preset radio stations.

A

  Press SOURCE repeatedly until ‘FM’ or 

‘AM/MW’ appears

B

  Press and hold u until ‘GRID 9’ or 

‘GRID 10’ appears.

You can store up to 40 preset radio 
stations in the memory. There are three 
different ways to program the radio 
stations:

–  Using auto install (for fi rst time setup 

only)

–  Using automatic preset 
–  Using manual preset 

When you access the ‘RADIO’ mode for 
the fi rst time, you will be prompted to 
install the radio stations.  With this 
feature, you can install all the available 
radio station automatically with one 
touch of button. 

A

 Press RADIO on the remote control

 ‘AUTO INSTALL ... PRESS PLAY’ 

appears. 

B

 Press u until ‘START... SEARCH’ 

appears on the display panel.

 The system will start searching from 

the FM band followed by the AM/MW 
band.

 All available radio stations with strong 

signal will be stored.

 Once complete, the fi rst tuned radio   

station will be played back.

  To stop the tuner installation, press 

STOPÇ on the remote control.

1_htr5205-98_EN.indd   21

1_htr5205-98_EN.indd   21

2007-03-30   11:53:53 AM

2007-03-30   11:53:53 AM