Philips HTR5205 User Manual

25

WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate 
the warranty. Never open the system as there is a risk of electric shock.

If a fault occurs, fi rst check the points listed below before taking the system for repair. 
If you are unable to solve a problem by following these instructions, consult your dealer or
Philips for help.

–  Press STANDBY-ON on the unit to turn on the 

power.

–  Make sure the mains cord is properly connected and 

the AC outlet has power.

–  Adjust the volume.
–  Check the speaker connections and settings.
–  Make sure that the audio cables are connected and 

press SOURCE to select the correct input source (for 
example, TV or AUX) to choose the device that you 
want to hear through this unit.

–  Press  VOL +- to adjust the volume level.  
–  Make sure the centre and rear speakers are 

connected correctly. 

–  Press SURROUND button to select a correct 

surround sound setting. 

–  Make sure the source you are playing is recorded or 

broadcast in surround sound (DTS, Dolby Digital, etc.).

–  If the signal is too weak, adjust the antenna or 

connect an external antenna for better reception.

–  Increase the distance between this unit and your TV 

or VCR.

–  Tune in to the correct frequency.
–  Place the antenna further away from any equipment 

that may be causing the interference.

–  Select the source you want to play (for example, 

DISC/DI or RADIO) before pressing the function 
button [W(.) / X (>)].

–  Reduce the distance between the remote control and 

this unit.

–  Batteries are weak, replace the batteries.
–  Point the remote control directly toward the IR 

sensor.

–  Check that the batteries are inserted correctly.

–  Place the recei

ver as far away from any electrical 

devices that may be causing the interference.

1_htr5205-98_EN.indd   25

1_htr5205-98_EN.indd   25

2007-03-30   11:53:53 AM

2007-03-30   11:53:53 AM