Philips MX-965 User Manual

You can search for radio stations by scanning the frequency
band. You can also key in the frequency of a known radio
station. If an FM station is being broadcast and received in
stereo, 

is shown.

Searching for radio stations
1 Turn SOURCE SELECTOR to select the tuner.

y

TUNER is displayed.

2 Select a waveband by pressing TUNER BAND repeatedly.

y

The selected waveband is displayed.

3 Keep 

1 or 2 pressed for approximately 1 second.

y

SEARCH is displayed and the tuner tunes to a station
with sufficient strength.

4 Repeat this procedure until you find the desired station.

• To fine tune to a weak transmitter, briefly press 

1 or 2 as

often as necessary for optimum reception.

Tuning to a radio station by frequency (with the remote
control only)
1 Press TUNER.

y

TUNER is displayed.

2 Press FR. D..

y

_ is displayed.

3 Use 1–0 to key in the frequency of a radio station.

You can switch the tuner to a lower search sensitivity, to
search only for stations with a strong signal (FM only).

1 Turn SOURCE SELECTOR to select the tuner.

y

TUNER is displayed.

2 Press SENS. on the receiver.

y

Either 

or 

is displayed for 5 seconds.

You may store up to 30 radio stations in the memory. The
receiver can select and program radio stations by itself or you
can choose them yourself.

Automatic programming
1 Choose 

* TUNER from the menu and press NEXT 2.

2 Choose 

AUTO INSTALL and press NEXT 2.

y

The preset number where programming will start, the
waveband and

AUTO are displayed.

3 Turn TUNER PRESET 

X to change the preset number where

programming should start.

4 Use TUNER BAND to switch to the desired waveband.

5 Press ENTER / OK to start programming.

y

AUTO INSTALL flashes and all available radio
stations are programmed, this may take a few minutes.
Programming is done when 

AUTO INSTALL stops

flashing.

Manual programming
1 Choose 

* TUNER from the menu and press NEXT 2.

2 Choose 

MAN INSTALL and press NEXT 2.

y

A preset number, the waveband and the frequency are
displayed.

3 Turn TUNER PRESET 

X to change to the preset number

where the radio station should be stored.

4 Tune to the desired radio station (see “Searching for radio

stations”).

5 Press ENTER / OK to confirm your selection.

y

STORED is displayed briefly. The radio station is
programmed at the chosen preset number.

6 Select and store all desired radio stations this way.