Philips VR1000 User Manual
— 14 —
Setting the Video Channel
The video Channel (RF Output Channel) is the channel on which your TV receives picture and sound signals from the
VCR through the RF cable.
VCR through the RF cable.
IMPORTANT
Perform the following steps only if –
– Video Channel Set has not been done correctly by the Auto Set Up function. (✈P.11)
– you set up the VCR’s tuner by Preset Download (✈P.13) instead of using the Auto Set Up function.
– interference appears in the TV picture after you have moved to a different area or a new station has started broad-
Perform the following steps only if –
– Video Channel Set has not been done correctly by the Auto Set Up function. (✈P.11)
– you set up the VCR’s tuner by Preset Download (✈P.13) instead of using the Auto Set Up function.
– interference appears in the TV picture after you have moved to a different area or a new station has started broad-
casting in your area.
– you change the connection between your recorder and TV from RF connection to Scart or S-Video connection, or
vice versa.
1
Make sure the VCR is turned off and no cassette is inserted.
2
Turn on the TV, and tune it to any UHF channel (between 22 and 69) you want to use as the video channel on the TV.
• Select a channel not used in your area.
3
Press
STOP/EJECT
7
/
0
on the front panel for more than 5 seconds.
The following indication appears on the display.
4
Press
PROGRAMME or PROG. +/–
to select the channel you have tuned on the TV as the video channel in step 2.
A test signal (two vertical white bars) appears on the TV.
5
Press
OK
to finish the video channel setting.
To watch a picture from this VCR on the TV, select the same channel you have selected as the video channel (in step 2
above) on the TV.
above) on the TV.
Channel number starts flashing.
Test signal
(two vertical white bars)
(two vertical white bars)
If you use SCART connection or S-Video connection,
You do not need the video channel so you have to set
the video channel to off. To turn it off, press
PROGRAMME – or PROG. – until “– –” appears on
the channel number position.
You do not need the video channel so you have to set
the video channel to off. To turn it off, press
PROGRAMME – or PROG. – until “– –” appears on
the channel number position.
S
ETTING
U
P
(C
ONTINUED
)
VR1000/07-New
99.7.8, 3:29 PM
14