Hatco pmg-60m-0705(7) User Manual

Form No. PMG-60M-0705

22

q. Remove the two (2) side screws from the

burner and lift the heat exchanger out of the
bracket.

r. Remove the heat exchanger high limit switch

from old heat exchanger and place onto new.

s. Reverse steps (h) - (r) to reassemble unit.
t. Seal threads of drain plug with a food grade

sealant to prevent leakage and install in 
new exchanger.

u. Reconnect water and gas lines and relief 

valve plumbing.

v. Close drain valve under booster heater and

turn on water supply to booster, then turn on
electrical supply and allow pump to displace
trapped air out of the new heat exchanger,
then purge this air out of the booster by
running several rinse cycles on the
dishmachine. CHECK ALL FITTINGS FOR
LEAKS.

w. Turn on gas supply (CHECK ALL FITTINGS

FOR LEAKS) and follow start-up procedures.

12.Blended Phosphate Water  Treatment Cartridge

Replacement

a. Shut off electrical power to the heater.
b. Shut off water supply and open drain valve to

remove water in piping.

c. Loosen canister using wrench attached.
d. Remove canister and discard depleted

cartridge.

e. Use a clean damp cloth, wipe interior of 

canister clean.

f. Reverse above procedure to reinstall.