MGE UPS Systems 2200RT User Manual

Page 26 - 

3400753300/AE

Upper and lower voltage thresholds within which the UPS can operate on the automatic

bypass in the event of a UPS fault or overload. 

Automatic switch controlled by the UPS, used to connect the equipment directly to the
AC-power source in the event of a UPS failure or an overload.

This function automatically starts the UPS when AC input power returns following 

shutdown at the end of the battery backup time. It can be enabled or disabled.

Time that the connected equipment can operate on battery power.

Device on the front panel indicating the percent remaining backup time or the percent 
load.

Internal UPS test on battery status.

A window in a computer program displayed for selection by the user of various options 
and parameter settings.

The power supplied to the connected equipment is completely regenerated by 
continuous double conversion, i.e. the AC power from the AC-power source is rectified 
(AC - DC), then converted back (DC - AC) to AC power.

Devices or systems connected to the UPS output.

Ten-second interruption in the supply of power to the connected equipment following a 
system shutdown, even if AC input power returns during the interruption period.

Ratio between the power drawn by the connected equipment and the total power that 
the UPS can supply.

A number of UPS functions can be modified using the UPS Driver software to better 
meet the user’s needs.

Outlets that can be automatically shed during operation on battery power (a shedding 
time delay may be programmed using Solution-Pac software.

External dry contact can be used to stop the unit, during an emergency situation for 
example. All power is removed from the load.

This function makes it possible to energize the connected equipment even when AC 
input power is not available (operation exclusively on battery power).

Uninterruptible Power Supply.

It is possible to enable or disable use of UPS ON / OFF controls by the computer-
system protection software.