MGE UPS Systems EXB10Rack User Manual

10

Rack: 86-153522-00

MGE UPS SYSTEMS

c

observe the safety rules indicated at the

beginning of this document.

c

check that button 3 "

" on the front is

not pushed in;

c

check that rating shown on identification

plate  9  corresponds to the input voltage
specification and power requirement of your
application.

c

input power to Pulsar as shown.
Connect the computer cord 5 between
UPS utility power receptacle

4  , and a

nearby utility power outlet.

Note 1:
Following connection, the battery
automatically charges, whatever the position
of the ON/OFF button 3  "

"  .

Note 2:
The batteries will provide full back-up time
after approximatively 8 hours of recharge
time.

Note 3:
The rating of input power cord must  not be
less than the nominal input rating of
Pulsar EX10

Rack: Use the supplied cord.

c

battery extension module (optional):

v

check that button   3   "

" on the front of

the Pulsar EX10

Rack is not pushed in,

v

disconnect the utility power connection

cord   5 ,

v

flip the circuit-breaker   20   of the unit to

the right (position "O"),

v

connect the battery connection cord   23

to connector   21   of the module and
connect   13   of the Pulsar EX10

Rack,

v

if the installation has 2 battery modules,

connect the second cord   23   to connectors
21   of the second module and   22   of the
first module,

v

the use of connectors   13 ,  21  and   22

is strictly limited to connecting the battery
modules to the Pulsar EX10

Rack. Any other

connection to these connectors is prohibited
at the risk of damaging the battery and
losing the warranty,

v

flip the battery circuit-breaker   20   to the

left (position "I"),

v

if your installation is operated with MGE

UPS SYSTEMS software, update your
battery configuration with EX Tuner.

c

use IEC cords to connect your

applications to output sockets 7 .

Vac IN

computer
loads

utility
power
outlet

 

Vac IN