Mercedes Benz 2007 r 320 cdi User Manual

Page of 570
264
Controls in detail
Panorama roof with power tilt/sliding panel*
Synchronizing the panorama roof with 
power tilt/sliding panel
The tilt/sliding panel and its roller 
sunblinds must be synchronized
after the battery has been 
disconnected or discharged
after a malfunction
if the tilt/sliding panel does not open 
smoothly
Switch off the ignition (
remove the SmartKey from the starter 
switch.
Vehicles with KEYLESS-GO*:
Switch off the ignition (
Open the driver’s door (this puts 
the starter switch in position 0
same as with the SmartKey re-
moved from the starter switch). The 
driver’s door then can be closed 
again.
Remove the fuse for the tilt/sliding 
panel from the fuse box (
Reinsert the fuse in the fuse box.
Switch on the ignition (
Push and hold the roof panel switch in 
direction of arrow
2 (
until the roller sunblinds are fully 
closed.
Keep holding the roof panel switch in 
direction of arrow
(
page 263) for 
approximately 1 second.
Pull and hold the roof panel switch in 
direction of arrow
(
until the roller sunblinds are fully 
opened.
Keep holding the roof panel switch in 
direction of arrow
(
page 263) for 
approximately 1 second.
!
Do not attempt to open or close the 
tilt/sliding panel before the tilt/sliding panel is 
properly synchronized. The tilt/sliding panel 
could otherwise lock-up in the open position.
If the tilt/sliding panel cannot be closed or 
synchronized, see an authorized Mercedes-Benz 
Light Truck Center or call Roadside Assistance 
(
i
For information on which fuse box contains 
the fuse for the power tilt/sliding panel, see the 
fuse chart provided with the vehicle tool kit 
(