Mercedes Benz 2007 r 320 cdi User Manual

Page of 570
68
Getting started
Parking and locking
Releasing seat belts
Press the seat belt release button 
(
Allow the retractor to completely re-
wind the seat belt by guiding the latch 
plate.
Locking
Exit the vehicle and close all doors and 
the tailgate.
Locking with the SmartKey
Press button
‹ on the SmartKey 
With the tailgate and all doors closed, 
the turn signal lamps flash three times. 
The locking knobs on the doors move 
down. The anti-theft alarm system is 
armed.
!
Make sure the seat belt retracts fully so that 
the seat belt and/or latch plate cannot get 
caught or pinched in the door or in the seat 
mechanism. This can damage the seat belt and 
impair the effectiveness of the seat belt, and/or 
cause damage to the door and/or door trim pan-
el. Such damage is not covered by the 
Mercedes-Benz Limited Warranty.
Damaged seat belts must be replaced. 
Contact an authorized Mercedes-Benz Light 
Truck Center.
Warning!
G
To prevent possible personal injury, always 
keep hands and fingers away from the door 
openings when closing the doors. 
Be especially careful when small children 
are around.
Before closing doors, make sure there is no 
possibility of someone getting caught in a 
door during closing.
Warning!
G
When leaving the vehicle, always remove the 
SmartKey from the starter switch, take the 
SmartKey with KEYLESS-GO* with you, and 
lock your vehicle. Do not leave children 
unattended in the vehicle, or with access to 
an unlocked vehicle. Unsupervised use of 
vehicle equipment may cause an accident 
and/or serious personal injury.
i
If you hear a warning signal, you have 
forgotten to switch off the exterior lamps before 
opening the driver’s door.
In addition the message 
Switch off lights 
appears in the multifunction display.
Switch off the exterior lamps.