Monessen Hearth mhsc eyf18 User Manual
65D1009
21
LOG PLACEMENT
PLACING THE DECORATIVE ROCK
Figure 18 - Installing EYF24-F Logs on Burner
Before you begin — This unit is supplied with a four ceramic fiber log units. Do not handle the log unit with your bare
hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the log unit, wash your hands
gently with soap and water to remove any traces of fibers.
hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the log unit, wash your hands
gently with soap and water to remove any traces of fibers.
Top Left Log
(#3)
Main Log
(#1)
Front Log
(#2)
Top Right Log
(#4)
Grate Bars
CAUTION
DO NOT sprinkle volcanic rock on the
logs or around the pilot or the main
burner. This may cause sooting. Only
place volcanic rock on the floor of the
fireplace.
During initial operation of the new
heater, burning logs will give off
a paper burning smell and orange
flames will be present. Simply open
the windows for a few hours to vent
the odor.
logs or around the pilot or the main
burner. This may cause sooting. Only
place volcanic rock on the floor of the
fireplace.
During initial operation of the new
heater, burning logs will give off
a paper burning smell and orange
flames will be present. Simply open
the windows for a few hours to vent
the odor.
WARNING
The positioning of the log unit is critical
to the safe and clean operation of this
heater. Sooting and other problems may
result if the logs are not properly and
firmly positioned in the appliance. Never
add additional logs or embellishments
such as pine cones, vermiculite or rock
wool to the heater. Only use the log uit
supplied with the unit.
Failure to position the parts in accordance
with diagrams below or to use only
parts specifically approved for this
heater may result in property damage
or personal injury.
to the safe and clean operation of this
heater. Sooting and other problems may
result if the logs are not properly and
firmly positioned in the appliance. Never
add additional logs or embellishments
such as pine cones, vermiculite or rock
wool to the heater. Only use the log uit
supplied with the unit.
Failure to position the parts in accordance
with diagrams below or to use only
parts specifically approved for this
heater may result in property damage
or personal injury.
Tabs
INSTALLING EYF24-F LOG UNIT ON BURNER
1. Install Main Log (#1) on middle and rear supports of base.
1. Install Main Log (#1) on middle and rear supports of base.
Tabs should fit inside log center opening. Check log posi-
tion and stability. See Figure 18.
tion and stability. See Figure 18.
2. Install Front Log (#2) in front of burner and behind grate.
See Figure 18.
3. Rest rear end Top Left Log (#3) in the indention on the main
log. Line up hole in bottom of Top Left Log (#3) with slot
on Front Log. See Figure 18.
on Front Log. See Figure 18.
4. Position rear end of Top Right Log (#4) on indention of
main log. Rest front end of Top Right Log (#4) on front
lot. See Figure 18.
lot. See Figure 18.