Human Touch ht-135 User Manual
REMOVING THE BACKREST COVER
1. Power off the chair and unplug it.
2. Push down on the backrest release lever, then fold the backrest forward
onto the chair seat (Fig.1).
3. Using a Phillips-head screwdriver, remove the four screws that secure
the remote control bracket to the backrest cover (Fig.2).
onto the chair seat (Fig.1).
3. Using a Phillips-head screwdriver, remove the four screws that secure
the remote control bracket to the backrest cover (Fig.2).
4. Pull the remote control cables through the backrest cover, then disconnect the cables.
5. Using a 4 mm (5/32") Allen key, remove the four backrest cover screws (Fig.3).
Tools Required: 4 mm (5/32") Allen key, Phillips-head screwdriver.
SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY
Backrest release lever
Backrest cover
(Fig.1)
(Fig.2)
(Fig.3)
1
REPLACING THE BACKREST COVER
HT-135
It is imperative that Human Touch
®
products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used
during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair
instructions. Failure to adhere to these instructions voids the product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.
instructions. Failure to adhere to these instructions voids the product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.
SERVICE LEVEL: 2
July 30, 2013