Microboards Technology orbit 3 User Manual
Orbit 3 MICROBOARDS TECHNOLOGY, LLC
6
Installation Requirements
System
Setup
• Connect the power cable to the Orbit 3 duplicator and plug in to a protected power outlet strip or UPS
power supply.
• Turn on power to the duplicator.
• Install the Input Rods and Output Bin. The system is now ready to use.
Install your Orbit 3 duplicator in the following environment:
9
On a level and stable surface
9
In a well ventilated location
9
Temperature: 40-100
° F (5-40° C)
9
Humidity: 20-80%RH (no dew formation)
9
In an area with enough space to access the reject area behind the Orbit 3
9
In an area with enough vertical space for loading the Input bin
9
In an area with enough space for the Output Bin
Do not install your Orbit 3 duplicator in the following places:
8
Under direct sunlight (If the machine is exposed to sunlight, the light should be blocked by a curtain or
blind.)
blind.)
8
A dusty location
8
A place where there is a lot of vibration
8
Near open flame
8
A place where the temperature and humidity change drastically
8
Near a heating device such as a heater or furnace
8
A location where air from an air conditioner blows directly onto the unit
8
Near a container filled with water
In winter during times of low humidity or in a location where static electricity is
generated, use an anti-static-electricity mat or humidifier to prevent static electricity.
Installing the Input Rods
The input rods should be installed onto the Orbit 3 before attempting to load the Input bin.
The short, wide rod is shipped in the correct location, in the far left Input rod position. The remaining 2 long
input rods should be installed on the right.
The short, wide rod is shipped in the correct location, in the far left Input rod position. The remaining 2 long
input rods should be installed on the right.
Power supply
Use house current as the power source for the unit.
Do not use an outlet near a motor driven appliance (i.e. air conditioner, copying machine).
Use an outlet with stable power supply voltages.
Do not overload an outlet. Do not use a service outlet from a PCs or other office machine.
Do not touch the power cord with a wet hand.
Be careful not to damage the power cord.
Inspect the power cord periodically.
In the event that the power cord is damaged, replace the power cord.
In the event that the power cord is damaged, replace the power cord.