Kurzweil smp18sup User Manual

Page of 5
.S.M.P.  1.8 Manual Supplement 
1
Rev. A 23-MAR-89
BETA TEST VERSION 1.8 SUPPLEMENT TO:
VERSION 2.0 ADDENDUM TO:
KURZWEIL 150 FOURIER SYNTHESIZER
SOUND MODELING PROGRAM VERSION 1.0 USER’S GUIDE
Rev. A
MARCH 23, 1989
This supplement describes the new features of Beta Test Version 1.8 of the Apple II Sound Modeling Program for the 
Kurzweil 150 Fourier Synthesizer.   Among these is a new version that will run properly on an Apple II-GS with a Passport 
(or equivalent) MIDI interface card.  In addition, some bugs in Version 1.7 have been fixed.
If you have an Apple II+, IIe, or IIc, please refer to the Version 2.0 Addendum first for instructions on installing .S.M.P.  on 
your particular computer.  Please note that wherever in these instructions the underline character (_) appears in disk 
filenames, you should type a minus sign (-) instead. Also, please substitute 1.8 for 2.0 when seen as part of a filename.
If you have an Apple II-GS, please read section 2.0 (Installation) in the Version 2.0 Addendum and then refer to Section 1 in 
this supplement for II-GS specific installation instructions.
If you wish to install a screen print program, ignore Section 2.5 of the 2.0 Addendum and instead refer to Section 2 in this 
Supplement.  There are now more options for installing a screen print routine.
After getting .S.M.P.  installed on your computer, you should read over the bound Version 1.0 manual in order to get started, 
keeping in mind that some of the menus have changed slightly.  When familiar with basic operations (or to resolve a 
discrepancy in the 1.0 manual), read through the 2.0 Addendum for a discussion of the new features introduced by Version 
1.7.  Finally, check out Section 3 of this supplement for new Version 1.8 specific features. A few sounds were added to the 
library; these are described in Section 4.  If you are interested in joining an Additive Synthesis Special Interest Group, fill out 
the questionnaire on the last page and return it.
TABLE OF CONTENTS
1.  APPLE II-GS INSTALLATION
2.  INSTALLING A SCREEN PRINT PROGRAM
2.1 Print Program Descriptions
2.2 Print Program Installation Instructions
3.  NEW VERSION 1.8 FEATURES
3.1 Apple II-GS Mouse Operation 
3.2 SKEW Option in Time Adjust Menu 
3.3 K150FS Program Rename Option in PROGRAM Menu
4.  VERSION 1.8 SOUND LIBRARY ADDITIONS
1.
APPLE II-GS INSTALLATION
If you have not already done so, please read Section 2.0 of the Version 2.0 Addendum which explains how the .S.M.P.  
Distribution Disk is organized, how to make a backup copy of its label side, and why an installation procedure is
necessary anyway.  Note that a 5 inch disk drive is needed to run S.M.P.  on the II-GS and that it runs under Apple DOS 3.3, 
rather than the more common PRODOS.