Human Touch ht-270 User Manual

REMOVING THE BACKREST COVER

1. Use the remote control to raise the backrest to a fully upright position.
2. Power off the chair and unplug it.
3. Using a Phillips-head screwdriver, remove the two screws that secure the remote control bracket

to the backrest cover (Fig.1).

4. Pull the remote control cables through the backrest cover, then disconnect the cables.

5. Using a 5/32" (4mm)

Allen key, remove the four backrest cover screws. (Fig.2).

6. Tip the backrest cover backward then lay it carefully

on the floor behind the chair.

7. Disconnect the three connectors (Fig.3).
8. Remove the backrest cover.

Tools Required: 5/32" (4mm) Allen key

, Phillips-head screwdriver

(4mm) Allen key

NOTE: SAVE ALL SCREWS FOR USE DURING REASSEMBLY.

REPLACING THE BACKREST COVER

HT-270

06/01/08

(Fig.1)

(Fig.2)

(Fig.3)

To ensure that Human Touch

products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all

product repairs are performed using only factory-new parts and in accordance with these product repair instructions.

SERVICE LEVEL: 2