Hitachi dzmv100e User Manual
75
Useful Functions during Recording of Movie
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Switching Movie Quality Mode.
You can switch the movie quality between "FINE" and "STND".
However, record critical subjects in the "FINE" mode.
However, record critical subjects in the "FINE" mode.
Block-like noise may appear in recorded image, or the outline of subject image is
distored under the recording conditions listed below: Pan the camera/recorder as
slowly as possible. (Block noise is likely to appear in the "STND" mode):
distored under the recording conditions listed below: Pan the camera/recorder as
slowly as possible. (Block noise is likely to appear in the "STND" mode):
•
If there is a complicated pattern (trees, fence, etc.) in background (as in follow-
ing figure on left)
ing figure on left)
•
If the camera/recorder is panned or tilted greatly or rapidly
•
If subject is moving rapidly even when the camera/recorder is not moving
1. Press the MENU button in the recording pause status to display
the menu screen.
2. Use the Select dial to choose “REC
SETUP” and then “V.QUALLTY”.
Options will be next to V. QUALITY: “FINE” is
being highlighted.
being highlighted.
3. Turn the Select dial to highlight
“STND”, and then press the Select dial.
The menu screen for setting record mode will
be restored, and “STND” has been specified.
be restored, and “STND” has been specified.
4. Press the MENU button to switch off the menu screen.
(Image when block-like noise occurs)
(Image without block-like noise)
E-P54-88
01.1.29, 3:05 PM
Page 75
Adobe PageMaker 6.5J/PPC