GE 175d1807p270 User Manual

Page of 16
OTHER
Possible Causes
What To Do
Labels on the exterior 
Occasionally the adhesive
Use a hair dryer set at the lowest heat setting, directing
of the washer will not 
used on the labels does 
the air at the label for a short amount of time. This will
peel off cleanly
not release cleanly
release the adhesive easily, without damaging the surface 
of the washer.
NOISE
Possible Causes
What To Do
Washer is noisy
Washer is uneven
To level the front of the washer, adjust the front leveling 
legs by rotating the individual leg in the proper direction 
for up or down. To level back of washer, lift back of 
machine 4
and set down.
Washer load is
Push the Cycle knob in to stop the washer, open the lid 
unbalanced
and redistribute the load evenly. Close the lid and restart.
Shipping rod is still assembled 
To remove shipping rod from washer, pull yellow tag and 
in unit
attached rod from the bottom right hand side of washer.
Washer is sitting too close 
Pull washer away from the wall; about 4
is needed.
to wall (causes knocking 
during cycle)
(con) PERFORMANCE
Possible Causes
What To Do
Pilling
Result of normal wear on
While this is not caused by the washer, you can slow the 
poly-cotton blends and
pilling process by washing garments inside out.
fuzzy fabrics
Snags, holes, tears, rips
Pins, snaps, hooks, sharp
Fasten snaps, hooks, buttons, and zippers.
or excessive wear
buttons, belt buckles,
Remove loose items like pins, objects in pockets
zippers, and sharp objects
and sharp buttons.
left in pockets
Turn knits (which snag easily) inside out.
Undiluted chlorine bleach
Check bleach package instructions for proper amount.
Never add undiluted bleach to wash or allow clothes 
to come in contact with undiluted bleach.
Chemicals like hair bleach
Rinse items that may have chemicals on them before
or dye, permanent wave
washing.
solution
Wrinkling
Improper sorting
Avoid mixing heavy items (like work clothes) with 
light items (like blouses).
Try a fabric softener.
Overloading or
Load your washer so clothes have enough room 
incorrect water level
to move freely.
Incorrect wash and
Match Cycle selection to the type of fabric you are
dry cycles
washing (especially for easy care loads).
Repeated washing in
Wash in warm or cold water.
water that is too hot
Before you call for service…
14
Operating Instructions
Safety Instructions
Customer Service
Troubleshooting T
ips