Hitachi CMP5000WXU User Manual

Step 2. As shown in figure, hook the stand pipe holes onto the screw heads of the installation bolts 1, then slide the stand

upwards to the main plasma display until it engages the installation bolts 1 (once put together with the display, the stand
will slides no more than 19 mm (3/4 inch)).

Step 3. Pass the installation bolts 2 (M8 x 40) through the stand pipes and tighten the installation bolts securely with the included

hexagonal wrench.

Step 4. Tighten the installation bolts 1 securely with the hexagonal wrench provided.

• Place a sheet or protective cover to protect the

display from scratches or damage.

• Assemble only with the plasma display lying flat

on a table or similar surface.

• Insert the bolts vertically in the holes and tighten

them, but do not apply excessive pressure that
tightens them more than necessary.

• Move the stand so that the stand screw holes

and the nuts that connect the main display line
up correctly.

• The display is a 50" model that weighs

approximately 40 kilograms (88 lb) and has little
depth, making the display very unstable. For this
reason, at least two people are required for
setup and installation.

Installation bolts 2 (M8 x 40)

(Step 3) 

Table top stand

Slide the stand (Step 2)

Sheet

■ Instructions for using the main display packing material as a stand for the working on

◆ Main plasma display packaging setup

Step 1. Construct the stand for the plasma display using the inner box frame and pads shown in the figure above (all pads are

identical).

Step 2. Set the plasma display down on the pads as shown in the figure below.

Step 3. Follow the instructions in Steps 1-4 in "Normal Installation" to attach the stand to the plasma display.

Outer box

Inner box frame

Pad

Mirror mat

Pad

Plasma display

Pad

Inner box frame

Plasma display

Inner box frame topped by two pads

Mirror mat

En