Hitachi VTFX-6400A User Manual
ELECTRONIC VIEWFINDER (EVF)
- 8 -
A. That the pins on plug of extension cord are the same number, size, and shape as those of plug on charger.
B. That extension cord is properly wired and in good electrical condition; and
C. That wire size should be met below:
Minimum AWG size
B. That extension cord is properly wired and in good electrical condition; and
C. That wire size should be met below:
Minimum AWG size
Length of extension cord (feet)
18
Equal to or less than 100
16
Equal to or less than 150
11. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way;
take it to a qualified serviceman.
12. Do not disassemble charger; take it to a qualified serviceman when service or repair is required. Incorrect
reassembly may result in a risk of electric shock or fire.
13. To reduce the risk of electric shock, unplug charger from outlet before attempting any maintenance or
cleaning.
take it to a qualified serviceman.
12. Do not disassemble charger; take it to a qualified serviceman when service or repair is required. Incorrect
reassembly may result in a risk of electric shock or fire.
13. To reduce the risk of electric shock, unplug charger from outlet before attempting any maintenance or
cleaning.
"Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to
Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the
cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as
practical".
Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the
cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as
practical".
ELECTRONIC VIEWFINDER (EVF)
Set the viewfinder to the position shown in the figure when carrying the camcorder or storing it in the carrying
case.
Turn the viewfinder to the position shown below when shooting pictures.
1. Turn the viewfinder.
2. Turn the eyepiece.
You can adjust the position and angle of the viewfinder so you can see through it easily.
CAUTIONS:
• Do not force the viewfinder to rotate completely around. This will damage the viewfinder and/or camcorder.
• When pulling the viewfinder out or returning it to its original position, hold the viewfinder by the swivel section.
Do not hold the diopter control side.
• Do not force the viewfinder to rotate completely around. This will damage the viewfinder and/or camcorder.
• When pulling the viewfinder out or returning it to its original position, hold the viewfinder by the swivel section.
Do not hold the diopter control side.