Hitachi VM-7400A User Manual

CAMCORDER TO VCR DUBBING 

- 32 - 

1. Insert the recorded tape into your VCR. 
2. Press "PLAY" of your VCR. 

NOTE: When noise appears in the played back picture, adjust "TRACKING" control on the VCR so there is no 
noise. 

1. Disconnect the VHF antenna leads from the rear of the TV receiver. 

NOTE: Leave the UHF antenna leads connected to the TV. 

2. Connect the VHF antenna lead to "IN FROM ANT" on the RF converter unit. If the cable is round (75 ohm), it 
will connect directly to the "IN FROM ANT". If it is the flat type (300-ohm), connect it to the antenna adaptor 
(300-ohm to 75-ohm) and slip the adaptor on to the "IN FROM ANT" terminal. 
3. Connect the 75-ohm coaxial cable with antenna adaptor to "OUT TO TV" on the RF converter unit. 
4. Connect the other end to the VHF antenna terminal on the TV, as illustrated. 
5. Connect the connector cable from RF converter unit to "RF DC OUT", "AUDIO" and "VIDEO" jacks on the 
camcorder. 
6. Turn on the TV and set to channel 3 unless channel 3 is one of the TV stations in your area. If channel 3 is 
used in your area, set your TV to channe14. 
7. Set the RF channel selector on the RF converter unit to "CH3" or "CH4" to match the channel selector on 
your TV. 
8. Perform same procedures in steps 4 through 7 of "Example 1". 

NOTE: If you want to watch a TV program with camcorder connected as illustrated, slide "CAM/OFF/VIDEO" of 
the camcorder to "OFF".