Hitachi vmh775le User Manual
CHARGING THE BATTERY
5
E
N
G
L
IS
H
The first step is to set the battery for charging. To charge the battery, attach it to the
camera/recorder, and connect the VM-ACE5E AC adaptor. Charge the battery at a
temperature range of 10 C – 30 C to prevent damage to the battery.
NOTES:
• This camera/recorder operates with a lithium ion battery such as VM-BPL13/VM-
camera/recorder, and connect the VM-ACE5E AC adaptor. Charge the battery at a
temperature range of 10 C – 30 C to prevent damage to the battery.
NOTES:
• This camera/recorder operates with a lithium ion battery such as VM-BPL13/VM-
BPL30/VM-BPL60.
• We cannot be responsible for any malfunctions of the camera/recorder which occur
when you use battery packs other than those specified.
To AC Outlet
To DC IN Jack
BATT. CHARGE Indicator
AC Adaptor
DC Plug
Charge the battery on a flat surface that is
free of vibration.
1. Make sure the CAM/OFF/VIDEO switch is
free of vibration.
1. Make sure the CAM/OFF/VIDEO switch is
set to OFF position.
2. Attach the battery pack to the camera/
recorder.
• Place the battery on the guide
• Place the battery on the guide
platform and slide it down so that it
fits into the camera/recorder.
fits into the camera/recorder.
NOTE:
Always attach a battery only by
the procedure described here.
Attaching a battery forcibly could
damage it.
Attaching a battery forcibly could
damage it.
3. Plug the AC adaptor power cord into an
AC outlet.
4. Connect the AC adaptor DC plug to the
DC IN jack of the camera/recorder.
Charging will start within five seconds.
During charging, the BATT. CHARGE
Charging will start within five seconds.
During charging, the BATT. CHARGE
indicator of the camera/recorder will
flash or light to give you a reference of
the charged level.
NOTES:
• If the BATT. CHARGE indicator
flash or light to give you a reference of
the charged level.
NOTES:
• If the BATT. CHARGE indicator
flashes once every two seconds, the
battery could be defective.
battery could be defective.
• The BATT. CHARGE indicator will not
light at all when the AC adaptor is
defective.
defective.
• You can
use the battery
before
it is
completely
charged.
• When charging
is complete,
the
BATT. CHARGE indicator
on
the
camera/recorder
will
light.
If the
fully
charged
battery
is
removed
and
then
re-attached,
the
camera/recorder
will
again
enter
the
charge
mode,
and
the
BATT. CHARGE indicator
will
flash.
It
will
take
a
few
minutes
for
the
camera/recorder
to
enter
the
charge
complete
status.
• Charging
at
low
temperatures
will
decrease
charge
capacity.
5. After
charging
is
complete,
disconnect
the
AC
adaptor
DC
plug
from
the
camera/recorder.
6. Disconnect
the
AC
plug
from
the
AC
outlet.
7. Detach
the
battery
from
the
camera/
recorder.
NOTES:
• Always
NOTES:
• Always
remove
the
battery
from
the
camera/recorder
after
use.
• Charging
is
not
done
when
the
CAM/
OFF/VIDEO
switch
of
the
camera/
recorder
is
set
to
CAM
or
VIDEO.
CAM/OFF/VIDEO
Switch
Switch