honda-automobiles 08e92-sna-100b User Manual

© 2008 American Honda Motor Co., Inc. - All Rights Reserved.

AII 38216-38957 (0802)

3.

Get the control unit. Using a small flat-tip
screwdriver, adjust the switches on the control
unit to the locations shown. Using a isopropyl
alcohol on a shop towel, clean the area where the
protective tape will attach. Attach the protective
tape to the control unit over the switches.

NOTE:
•

The switches must be selected before the
control unit is plugged in.

• If the switch setting is not correct, the engine

starter will not operate correctly.

• If setting the switches when the control unit is

installed in the vehicle, touch a metal part of
the screwdriver to a metal part of the vehicle
to discharge any static electricity.

• If you change the switch settings with the unit

connected, you must disconnect the unit, then
reconnect it before the settings will change.

SW : 1 RR Junction Unit
SW : 2 Trunk or Tailgate
SW : 3 Smart Entry
SW : 4 Horn or Buzzer Answer Back
SW : 5 Trunk Main SW
SW : 6 Reserve

4.

Remove the trunk lid/fuel fill door opener cover
(six retaining tabs). Remove one self-tapping
screw.

5202191T

www.collegehillshonda.com