ONKYO dv-sp504e User Manual

Page of 64
 
25
 
Connecting the DVD player
 
—Continued
 
To control the DVD player with the remote controller 
when DVD player is located in a cabinet, you’ll need a 
commercially available multiroom remote control kit.
• Multiroom kits are made by Niles and Xantech.
These kits can also be used when control other compo-
nents.
 
Using a Multiroom Kit with a Cabinet
 
In this setup, the IR receiver picks up the infrared signals 
from the remote controller and feeds them to the DVD 
player located in the cabinet via the connecting block.
The miniplug cable from the connecting block should be 
connected to the DVD player’s IR IN jack, as shown 
below.
 
Using a Multiroom Kit with Other 
 
Components 
 
In this setup, an IR emitter is connected to the DVD 
player’s IR OUT jack and placed in front of the other 
component’s remote control sensor. Infrared signals 
received at the DVD player’s IR IN jack are fed through 
to the other component via the IR emitter. Signals picked 
up by the DVD player’s remote control sensor are not 
output.
The IR emitter should be connected to the DVD player’s 
IR OUT jack, as shown below.
 
Using the Multiroom Control Kits 
(North American model only)
IR IN
Connecting 
block
Remote controller
IR Receiver
Inside 
cabinet
Signal flow
DVD player
From the connecting block
DVD player
Miniplug cable
IR IN
IR OUT
Connecting 
block
IR Receiver
Remote controller
Signal flow
IR Emitter
Other component
DVD player
Remote control 
sensor
Other component
Emitter
IR Emitter
Signal flow
Miniplug
Miniplug cable
DVD player
DV-SP504E_En.book Page 25 Wednesday, August 30, 2006 1:55 PM