Hitachi 26ld6200 User Manual

- 10 -

Before Switching On Your TV

Power Connection

IMPORTANT: The TV set is designed to op-

erate on 220-240V AC, 50 Hz.
• After unpacking, allow the TV set to reach the

ambient room temperature before you con-

nect the set to the mains.

Connections To The 

Aerial

 Input

Socket

9+)8+)

:

5($52)7+(79

&$%/(79

• Connect the aerial or cable TV plug to the

Aerial

 socket located at the back of the TV.

If you are also connecting a VCR, plug the

aerial cable into the aerial input socket on

the VCR and then connect the  RF output

cable from the RF out socket on the VCR to

the TV aerial socket. See P24 for further de-

tails.

How To Connect Other Devices

IMPORTANT: Switch off the TV before con-

necting any external device.
Sockets  for  external  connections  are  at  the

back and  side  of  the  TV.  For  connection  of

other devices via Euroconnector refer to the

manuals of the related devices.

Inserting Batteries In The Remote

Control Handset

• Place the batteries in the right directions as

seen below.

• Remove the battery cover located on the

back of the handset by gently pulling up-

wards from the indicated part.

• Insert two MN2400 AAA or equivalent type

batteries inside.

• Replace the battery cover.

Switching The TV ON/OFF

To switch the TV on:

Your TV will switch on in two steps:
1- Connect the power supply cord to the sys-

tem. Press On/Off switch at the rear of the

TV. Then the TV switches itself to stand-by

mode and the led becomes red located on

the front of the TV.

2- To switch on the TV from stand-by mode

either:

Press a digit button on the remote control so

that a programme number is selected,
or,
Press “ ”, "-P/CH" or "P/CH+"  button at the

top of the TV or press  “-P/CH” or  “P/CH+”

button  on  the  remote  control,  so  that  last

switched off 

mode

 is selected.

By either ways the TV will switch on and the

led becomes green.

To switch the TV off:

• Press the “stand-by” button on the remote

control, so the TV will switch to stand-by

mode and the GREEN LED will become

RED,

or,
Press  the  “ ”  button  located  on  the  top  of

the  TV,  so  the  TV  will  switch  off  and  the

GREEN LED will become RED.

01-ENG-26705W-1546UK-26 INCH TFT-(LG)(10 PAGE)(WO PIP)-50058455.p65

27.12.2004, 08:45

10