KVH Industries TracVision S2 User Manual

KVH TracVision S2

Displays for 5 seconds at startup

Software Version

Current software version
Alternates with “KVH TracVision S2”

Initializing

System initializing

Search Mode 1

Antenna Unit in Search Mode 1

Search Mode 2

Antenna Unit in Search Mode 2

Search Mode 3

Antenna Unit in Search Mode 3

Reacquisition

System is reacquiring the satellite

RF Signal Error

RF signal detector has no signal at input

AZ Motor Error

Fault detected in azimuth drive subassembly 

EL Motor Error

Fault detected in elevation drive subassembly

Differences among IRD low-speed data ports may result in
different message formats, and some messages may not be
displayed on the television screen. DIRECTV messages you may
see are listed in Table 2-4.

Searching for satellite –

The IRD is powered up and

please stand by

doesn’t detect the satellite signal.

Searching for program guide – 

The system has found the satellite,

please stand by

but has been turned off for more

than approximately four hours. This
message appears for about 
10 seconds.

Refer to your DIRECTV User’s Manual for specific messages
displayed by your system.