Hitachi c52-wd9000 User Manual

41

˄The function shown as below is designed for the C43-FL9000 model.˅

1.When non HD component signal is received 

You may set different aspect modes to view the image with different signal formats. 

You can change between four different modes,

lj4:3NJ, lj4:3 ZoomNJ,lj16:9NJandlj16:9 ZoomNJ.

Please see the following on each of four modes for details. 

ƽTo switch aspect mode, please press the P.SIZE button, the TV will display the corresponding aspect mode 

momentarily on the lower part of the screen. For example, set the current aspect mode to 

lj4:3NJ as shown on 

the lower left side. If 

lj4:3 ZoomNJ  is set as shown on the lower right side, you can press the ŸP+ źP-

cursor buttons to adjust the display position up and down before the words 

Ālj=RRPNJ6FUROOā

disappears as shown on the lower right side.       

`

2.When HD component signal is received 

Press the P.SIZE button to switch between two different modes,

lj16:9NJandlj16:9ZoomNJ.

Remark:
If you change program No. or power on the TV, the aspect mode will return to the mode of 

lj16:9NJ(when HD 

signal is received ) or

lj4:3NJ(when conventional signal is received). 

˖

1

ˊ Do not watch TV at non full screen, as this may cause damage to your PRT. 

2

ˊ Using this special function (aspect mode) to change the size of image displayed (i.e., change the ratio of 

height and width) for the purpose of public release or some commercial interests may infringe the  
copyright law. 

3

ˊ In multi picture, pressing the P.SIZE button does not function. 

ljNJ

Signal sources 

ljNJ

 

 

 

lj=RRPNJ

 

 

 

ljNJ

 

 

 

Suggested 

aspect

mode 

lj=RRPNJ

 

 

 

lj=RRPNJ6FUROO

For example:
Conventional TV 
broadcast format

For example: 
signal transformed 
from HD 

For example:
16:9 widescreen cinema