Hitachi c52-wd9000 User Manual

53

gBefore calling up the service personnel, please check the following chart for a possible cause to the problem you are encountering. 

The following phenomena are not failures:
˄1˅The picture takes a while to appear on the screen when the power is on. 
˄2˅The cabinet clicks. The clicking is a creaking sound produced when the cabinet expands or contracts   

due to changes in temperature. 

˄3˅Unevenness in color sometimes develops in part of the screen. Such unevenness in color may occur 

depending upon the nature or setting of the picture. The proper color may be restored by reducing the 
contrast or adjusting other settings. 

˄4˅The TV set can generate sound distortion in external devices such as a radio. Please place the radio 

equipment away from the TV set.

No picture,no sound,power/standby indicator is OFF.

gThe power cord is not plugged in. 

No picture,no sound,power/standby indicator is ON. 

gThe TV is in standby mode. 

No sound 

gThe volume control is set to minimum. 

gThe Speaker option in Setup menu is set to Off.

Twist image and poor sound 

gThe antenna signal is too weak or too strong. 

gThe TV is not tuned correctly. 

Poor brightness, color or tint 

gThe contrast, brightness, color or tint may be misadjusted. 

Snowy picture 

gInterference from motorcycles, high-tension line, electric hair drier, 

personal computer or radio station.   

Ghosts 

gCheck the direction, height or position of the antenna. 

No color 

gThe antenna signal is too weak. 

gColor System or Sound System is not set properly. 

Remote controller does not work. 

gThe batteries in the remote controller may be exhausted. 

gThe batteries may be improperly installed. 

gThere is obstruction between the remote controller and the TV. 

1

Instruction manual 

1

Yes 

Yes 

2

Remote control unit (CLE-962) 

1

Yes 

Yes 

3

Battery (For CLE-962) 

2

Yes 

Yes 

4

Caster holder 

4

Yes 

Yes 

5

Antenna adapter 

1

Yes 

Yes 

HITACHI Projection Television incorporates advanced power surge protection technology designed to protect against 
component or circuit damage due to external or internal power surges.   
If your TV appears A LOSS OF POWER, please follow the following procedure: 
1. Press the POWER button once. 
2.If there is still no power, wait for 30 seconds and press the POWER button again. 
3.If there is still no power, unplug the power cord from the wall outlet. Wait for 30 seconds and plug the power cord in. Press

the POWER button again. 

  The protective technology should provide you years of lasting entertainment from your HITACHI Projection Television.