GE 28821xx2 User Manual

Page of 68
Interference Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following 
two conditions: (1) This device may not cause harmful interference; and () This device 
must accept any interference received, including interference that may cause undesired 
operation.
This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause harmful interference 
to radio communications. However, there is no guarantee that interference will not occur 
in a particular installation.
Privacy of Communications may not be ensured when using this product.
If this equipment does cause harmful interference to radio or television reception, which 
can be determined by turning the equipment off and on, the user is encouraged to try to 
correct the interference by one or more of the following measures:
•  Reorient or relocate the receiving antenna (that is, the antenna for radio or 
television that is “receiving” the interference).
•  Reorient or relocate and increase the separation between the telecommunications 
equipment and receiving antenna.
•  Connect the telecommunications equipment into an outlet on a circuit different 
from that to which the receiving antenna is connected.
If these measures do not eliminate the interference, please consult your dealer or an 
experienced radio/television technician for additional suggestions. Also, the Federal 
Communications Commission has prepared a helpful booklet, “How To Identify and 
Resolve Radio/TV Interference Problems.” This booklet is available from the U.S. 
Government Printing Office, Washington, D.C. 00. Please specify stock number  
00-000-005- when ordering copies.
Notice: The changes or modifications not expressly approved by the party responsible 
for compliance could void the user's authority to operate the equipment.