Hitachi VM-H81A User Manual

Page of 72
General Maintenance 
 
60
 It is recommended that you store the camcorder in a box with a 
desiccant. 
 Store the camcorder without closing the snap and with the case slightly 
open. 
Periodic Maintenance 
A precision electromechanical device, the Hitachi VM-H81A requires 
maintenance after a period of normal use. We expect that no other 
maintenance other than head cleaning will be required during the period of 
warranty unless the camcorder is used either heavily or seldom. Defective 
parts are covered by the warranty. Normal maintenance is the 
responsibility of the owner. Consult your dealer or local VCR service 
center for recommendations regarding normal maintenance based on your 
use patterns, location, and the age of the camcorder. 
Troubleshooting 
Quality is very important at Hitachi. We inspect and check every 
camcorder carefully at the factory under the most rigid quality control and 
inspection systems. If problems develop please check the following 
possible solutions before inquiring about professional service. 
INSERTING OR REMOVING THE CASSETTE 
Symptom 
Check Point & Correction 
Cassette holder cannot be opened when 
you slide “EJECT” button 
Connect the power source. 
Cassette cannot be inserted into cassette 
compartment. 
Load cassette in direction indicated by 
arrow on cassette. 
 
Cassette window must be toward outside. 
 
CAMERA RECORDING 
Symptom 
Check Point & Correction 
Picture does not appear in the viewfinder. 
Remove the lens cap. 
 
`Slide the power switch to “CAMERA” 
 
Disconnect the AV input cable from the 
camera/recorder. 
The camera/recorder cannot go into the 
recording mode, even when the start/stop 
button is pressed. 
Check the record protect tab on the 
cassette. 
 
Make sure that the “FOCUS M” does 
not appear in the viewfinder.  If it is 
displayed, press “Focus” select button to 
erase it.  
Picture is out of focus. 
Auto-Focus does not operate if a special 
effects filter is attached. 
 
RECORDING TV PROGRAMS OFF THE AIR 
Symptom 
Check Point & Correction 
The camera/recorder can not be set to 
the recording mode, even when the 
start/sop button on the 
camera/recorder is pressed. 
Check the record protect tab on the 
cassette.   
 
Set the power switch to “CAMERA” 
position. 
 
Connect the camera/recorder and TV  
(or VCR).