honda-automobiles 08b26-s9v-100 User Manual

All 23607 (0205)

©

 2002 American Honda Motor Co., Inc - All Rights Reserved.

•

Remove the driver’s and passenger’s center
console trim pieces (three clips each). Take
care not to damage the clips.

Flat-tip screwdriver

Phillips

 

screwdriver

Shop towel

Diagonal cutters

10 mm Combination wrenches

Isopropyl alcohol

Utility knife

Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by “do-it-yourselfers.”

1.

Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
preset buttons.

2.

Disconnect the negative cable from the battery.

3.

Remove the audio unit.

•

Using a flat-tip screwdriver wrapped with a
shop towel, gently pry out on the audio panel
to remove the five clips. Unplug the connectors
and remove the audio panel.

•

Remove the four screws that fasten the audio
brackets. Pull the audio unit out toward you,
unplug the vehicle connector and antenna lead
from the rear of the audio unit.