Hanna Instruments hi 983327-0 User Manual

Manufacturers since 1978

These Instruments are in

Compliance with the CE Directives

Hanna Instruments reserves the right to modify the design, construc-
tion and appearance of its products without advance notice.

These meters are warranted for two years against defects in work-

manship and materials when used for their intended purpose and

maintained according to instructions. The probe is warranted for a

period of six months. This warranty is limited to repair or replacement

free of charge.
Damages due to accident, misuse, tampering or lack of prescribed main-

tenance are not covered.
If service is required, contact the dealer from whom you purchased the

instrument. If under warranty, report the model number, date of pur-

chase, serial number and the nature of the failure. If the repair is not

covered by the warranty, you will be notified of the charges incurred. If

the instrument is to be returned to Hanna Instruments, first obtain a

Returned Goods Authorization Number from the Customer Service depart-

ment and then send it with shipment costs prepaid. When shipping any

instrument, make sure it is properly packaged for complete protection.
To validate your warranty, fill out and return the enclosed warranty card

within 14 days from the date of purchase.
All rights are reserved. Reproduction in whole or in part is prohibited

Dear Customer,
Thank  you for choosing a Hanna product. This manual will

provide you with the necessary information for the correct

operation of the meter. Please read it carefully before using

the meter. If you need additional technical information, do

not hesitate to e-mail us at tech@hannainst.com.
These instruments are in compliance with the   directives.

HI  983327-0,  HI  983327-1  and  HI 98332700 are

conductivity  indicators and controllers with a relay output

designed for simplicity of use in a wide range of applica-

tions.
HI 98332700 is provided with a DC/DC converter which

isolates the measure system from the external power supply.
The models are panel mounted with membrane keypads on

the front panel and an easy-to-read LCD display.
All the meters automatically compensate for the temperature

variation. The probe is easy to clean and requires little

maintenance.
Measurements are highly accurate and the meters can be

calibrated at one point.
Power supply, wiring and selection are made via the plug-

in terminal blocks on the rear panel.
LED indicators on the front panel identify whether the

controller is in set or measurement mode,  and if alarm is
active.

Keypad
SET

To display
setpoint

To display
measurement

Trimmers
CAL

For
calibration

To adjust
setpoint

LEDs
SET

ON when LCD displays the set value

ON when LCD displays the measured value

ALARM ON when alarm contact is activated

1. Power Supply:

Positive

        230 VAC

Negative                    115 VAC

  -----                        Neutral

  -----

   Protection Earth

Note: the power input is internally protected by a 400 mA fuse

2. Alarm  Contact: A1, A2.

This contact acts as a switch for the power. The contact
has to be protected outside by the user.

Side view of the
panel-mounted unit
Supplied adjustable
location brackets al-
low the controller to
slide into the cutout
and will hold the unit
securely in place. 95
mm (3.74") is the mini-
mum amount of space
required to install the
controller.

3. Probe Connection: follow the above diagram and connect the
     colored wires of probe cable as indicated. It is recommended
    to connect the shield (P5) to avoid any interference.

Remove the instrument from the packing material

and examine it carefully. If any damage has oc-

curred during shipment, immediately notify your

Dealer or the nearest Hanna Customer Service Cen-

ter.
The meter is supplied with:

• Instruction manual;

• Mounting brackets.
Note: Conserve all packing material until the in-

strument has been observed to function correctly. Any

defective item must be returned in its original pack-

ing.