honda-automobiles 08v67-te0-100a User Manual
2 of 15
AII 37561-38377 (0711)
© 2007 American Honda Motor Co., Inc. – All Rights Reserved.
Flange bolt, 6 x 12 mm
Flange nut
4 Harness tapes
Accessory User’s Information Manual
Back-up Sensor Kit
P/N 08V67-TE0-100K
2 Center sensors
2 Center sensors
2 Corner sensors
(Blue)
(White)
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Flat-tip screwdriver
Ratchet
8 mm and 10 mm Socket
Pushpin
Drill
3 mm Drill bit
24 mm and 26 mm Hole saw
Ruler
Eye protection (safety goggles, face shield, etc.)
10 mm Combination wrench
File
Trim tool TN SILTRIMTL10
Phillips screwdriver
Flat-tip screwdriver
Ratchet
8 mm and 10 mm Socket
Pushpin
Drill
3 mm Drill bit
24 mm and 26 mm Hole saw
Ruler
Eye protection (safety goggles, face shield, etc.)
10 mm Combination wrench
File
Trim tool TN SILTRIMTL10
Illustration of the Back-up Sensor Installed on the
Vehicle
INSTALLATION
1.
Make sure you have the anti-theft code for the radio
and navigation system (if equipped), then write down
the radio presets.
and navigation system (if equipped), then write down
the radio presets.
Customer Information: The information in this
installation instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
“do-it-yourselfers.”
installation instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
“do-it-yourselfers.”
742308AE
CONTROL UNIT
2A FUSE
CASE
BUZZER
LEFT
CORNER
SENSOR
(WHITE)
RIGHT
CORNER
SENSOR
(WHITE)
RIGHT CENTER
SENSOR (BLUE)
LEFT CENTER
SENSOR (BLUE)
www.collegehillshonda.com