Havis-Shields c-vs-1200-expl User Manual

 

C-VS-1200-EXPL-INST-8-05 

TOOLS REQUIRED: 
 

Metric Socket Set 

 Ratchet 

Wrench 

 

Phillips Screw Driver 

 

Panel Pulling Tool

 

•  Remove the one 7mm Hex head screw located in the 

accessory pocket of the O.E.M. Console: 

•  Un-plugged the factory 12volt outlet in order to 

completely remove “FACE” of O.E.M. console. 

•  Remove top “FACE” of O.E.M console.  After Hex 

head screw is removed, simply pull straight up on 
“FACE” in the rear and then pull back to release the 
front of the console.  

•  Remove (2) 7mm hex head screws that attach the 

lower portion of the OEM console housing located under the HVAC controls. 

•  Remove (6) more 7mm screws located under the “Face” of the OEM console.  

•  Save all removed hardware, this will be used later to install the VS console. 

•  If equipped with the Traction control switch option, unplug and remove from OEM 

console.  

 

•  Place VS-Console where the “FACE” of the O.E.M console 

was originally located.  

•  Mount VS-Console using the (6) 7mm screws (removed 

earlier).  

•  If necessary, install traction control switch into the supplied 

plate. 

7mm Screw 

Mounting 
Hardware

“FACE

7mm Hex 

head screws