Hitachi VM-E53A User Manual

Getting Started 

 

27

vibrations. 
• If the DC camera light is turned on and off during recording, there could be noise in the 
picture. Watch the battery charge indicator especially when using a battery as the power 
source. 
• When the DC camera light is used, the operation time of the camera/recorder when a 
fully-charged battery pack is attached is halved. 

Depress the light to release the tab from the hook and then move the light in the 
direction of the arrow as shown in the figure. 

 

1. Turn the front of the case counter-clockwise and remove it. 

 

2. Remove the bulb by pulling it out through the opened case. 

 

3. Install the new bulb by aligning the notch in the rim of the bulb's base with the " " 
mark outside the socket. Avoid touching the bulb directly with your fingers. It may 
shorten the life of the bulb. 
4. Reattach the front of the case by placing the bulb in the hole of the reflective plate, 
lining up the smaller "-" mark on the front of the cover with the "-" mark on the DC 
camera light, and turning the front of the cover clockwise till the larger "-" mark on the 
front of the cover aligns with the "-" mark on the DC camera light. Check that the front of 
the camera light is attached properly before turning the light on.