Homelite 16151a User Manual
P/N 16151 A
Revised 3/6/2002
Instruction Sheet - Edger Guide
Wear eye protection when using this product
1. Place unit on a flat surface.
2. Using the short bolt, assemble the edger guide as shown in Figure
2. Using the short bolt, assemble the edger guide as shown in Figure
. Do not tighten wing nut at this point.
3. Remove wing nut, lock washer, flat washer and bolt from the deflector on the trimmer, as shown in Figure
.
NOTE: Put these parts aside for use later when the edger guide is removed.
4. Keeping deflector in place, lift trimmer slightly off the ground. Align edger as shown in Figure
. Press down firmly on guide with
thumbs and snap down onto tabs of deflector. Ensure that slots are aligned.
5. Using long bolt, install hardware as shown in Figure
.
6. Adjust edger guide to desired trimming length and tighten wing nut securely as shown in Figure
.