Honeywell herculine 2000 User Manual

Set Up and Calibration Procedures 

Overview 

Revision 7 

  HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual 

31 

7/08  

 

 

Once you have installed the actuator, you can verify, set or change certain operating parameters.  Set up is 
accomplished through use of the local display and keypad interface through your PDA with HercuLink

® 

software (see HercuLink

®

 manual 62-86-25-11) or via the HART

®

 communication option.  Please keep in 

mind that the unit is calibrated at the factory for your application and can be placed into service right out of 
the box.  Changing operating parameters may require recalibration of the actuator.   This section details the 
various operating parameters and functions of the actuator available using the local display and keypad 
interface, and calibration procedures.   

The alphanumeric display and keys on the keypad are the local operator interface for control, monitoring, 
and configuration of the actuator.  The display consists of a four character upper display and a six character 
lower display.  Six LEDs of various colors indicate actuator-operating status.  Directly below the display 
are six keys that allow you to setup, monitor, and control the actuator locally, as well as call up various 
operating parameters and configuration values on the display.  Figure 21 shows the physical features of the 
display and keypad. Table 6 summarizes the various functions you can perform using the keys as well as 
descriptions of the status indicators.  

 

Upper Display
(Four Characters)

Lower Display
(Six Characters)