Honeywell herculine 2000 User Manual
Set Up and Calibration Procedures
Auto - Manual Drive Switch
Auto - Manual Drive Switch
64
HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual
Revision 7
7/08
Auto - Manual Drive Switch
The Auto - Manual switch is located on the side of the actuator case below the handwheel. The switch
allows manual mode control of the actuator motor for set up, calibration and troubleshooting.
Figure 24 shows an illustration of the Auto - Manual switch and Table 24 describes the switch settings.
The Auto - Manual Drive switch setting overrides all input signals (analog signal and remote setpoint) and
local display mode settings. When not in auto the manual LED will flash every second.
allows manual mode control of the actuator motor for set up, calibration and troubleshooting.
Figure 24 shows an illustration of the Auto - Manual switch and Table 24 describes the switch settings.
The Auto - Manual Drive switch setting overrides all input signals (analog signal and remote setpoint) and
local display mode settings. When not in auto the manual LED will flash every second.
MANUAL
OFF
CW
CCW
OFF
A
U
T
O
AUTO - MANUAL DRIVE
Figure 24 Auto - Manual Switch
Table 24 Auto - Manual Switch Functions
Switch Setting
Motor Drive Control
AUTO
Actuator moves according to signal input and set up configuration.
CCW
Actuator moves to the fully counterclockwise position.
CW
Actuator moves to the fully clockwise position.
OFF
Actuator is idle.